It is suitable for the sealing and reinforcement of brick walls, cement mortar plastering layers, renovation putty layers with low hardness, and concrete top layers with putty removed. At the same time, it is also suitable for roughening the substrate of concrete layers.

• Reinforcing and roughening 

• Odorless and anti-alkali 

• Easier application

Application Method:

The substrate surface should be clean, dry, flat and free from dust and oil stains;

Whn used for the purpose of roughening, mix this product with cement (42.5 ordinary Portland cement is recommended) into a mixed slurry at a ratio of 1:2.0-2.25;

Apply evenly with a roller or brush, and ensure complete painting to avoid missing coating;

The next application procedure can only proceed after the reinforcement agent is fully dry.

Dilution Ratio:

For reinforcement purpose: Need to dilute with clean water, and the dilution ratio is 10%-30% (the ratio should be determined based on wall and weather conditions)

For roughening purpose: Do not use water to dilute.

Coverage rate:

For reinforcement purpose: 10-12m2/kg (one round), and actual consumption varies with substrate condition and dilution ratio.

For roughening purpose: 0.3-0.5m2/kg (one round), and actual consumption varies with substrate conditions.

1. Do not apply emulsion paint directly on this product;

2. Remove the old paint film before using this product;
   

3. Do not add cement into this product for the purpose of roughening. If roughening is needed, please use the 3TREES Two-Component Interface Agent;
   

4. Please do not apply in wet or cold weather (temperature < 5℃, relative humidity > 80%).
   

5. Precipitation during storage is a normal occurrence. Stir well before use.